Thankyou my friend i appreciate the reply and your detailed efforts you are a true gentlemen.
Ill be in touch !
Ill be in touch !
- Bienvenue sur Gamoover. Veuillez vous connecter ou vous enregistrer.
[move]
Vous vous épilez le maillot et collectionnez les bornes d'arcade avec des hommes musclés dessus ? Alors soyez les bienvenus sur Gamoover ! [/move]
Cette section vous permet de consulter les contributions (messages, sujets et fichiers joints) d'un utilisateur. Vous ne pourrez voir que les contributions des zones auxquelles vous avez accès.
Pages1
#1
Racecabs & Simulateurs / M2Pac : Comment convertir un Daytona USA "correctement"
Mercredi 07 Novembre 2018, 11:55:28 AM #2
Racecabs & Simulateurs / M2Pac : Comment convertir un Daytona USA "correctement"
Mercredi 10 Octobre 2018, 02:54:24 AM
Hello BP
I'm from Australia so not sure if this automatically translates across or you can read English lets hope :-). I'm am interested in starting this project as i have been wanting to build a Daytona for many years and finally have the time. I have very little electronics background so reading this post time and time again is slowly beginning to make sense so thankyou!. I have obtained a model 2 steering wheel console and and am about to source a drive board. Before i do so i wish to understand how to power the board up? and to which pins. Firstly can you suggest a power supply that will step down 110v from our 240 supply here in Australia and what specific Amperage to power the board, secondly indicate where the power pins (if i have missed this on an original post ) are located on the board. I apologize if this seems elementary. Thank you in advance
I'm from Australia so not sure if this automatically translates across or you can read English lets hope :-). I'm am interested in starting this project as i have been wanting to build a Daytona for many years and finally have the time. I have very little electronics background so reading this post time and time again is slowly beginning to make sense so thankyou!. I have obtained a model 2 steering wheel console and and am about to source a drive board. Before i do so i wish to understand how to power the board up? and to which pins. Firstly can you suggest a power supply that will step down 110v from our 240 supply here in Australia and what specific Amperage to power the board, secondly indicate where the power pins (if i have missed this on an original post ) are located on the board. I apologize if this seems elementary. Thank you in advance
Pages1