Sorry - my bad - it was PWM_centered.

It's just the constant pull right in rest position.  I can hear the motor buzzing.

simple! Genius - thank you Tibal!

Hi

I setup my PWM2HAPP this weekend.
Arduino mega 2560 - tx1 and gnd to PWM2HAPP
pwm_dir set
digital pwm ticked
1000000 baud rate
motor calibrated
steering calibrated
24v 10A PSU to PWM2HAPP
Wires to motor good.

I tried in fedit and boomslangs gui and got strange results (incorrect movements or nothing even though the log shows the event completed) plus the wheel always wants to turn straight to right (or left if I have it reversed in the backforcefeeder app).  I tried invert motor and invert torque (yes committing and resetting each time) still same - not going central at rest.

Yet......  I played Dirt 4 and assetto corsa - perfect just how it should be (I did increase the forcefeedback a bit).  Feedback was great - felt all rumbles on road, dirt, hitting walls and the countersteer feeling.

Is there something I missed that stops me from just having the wheel going to centre on power up (don't know if its a different type of board but I get no left right movement on power up either - even if disconnected from the Arduino)?


Many thanks
Brent

On a previous post, it showed how to setup different lights - like my view 1, view 2 and view 3 in a back and forth mode.
I setup a profile for the drive collection frontend and chose output 1, mapped it to light 4,5,6 (the view lights) and set to back and forth.
When I tick the 1 output the lights flash perfectly.

How can I make it so that profile has those lights constantly flashing?  I tried to save the control set whilst 1 output was active but it doesn't stay when I move back to default for example and back to the drive control set.
Can I force certain light states within a control set?

Thanks
Brent

That worked - all good now thanks.

Am I missing something with the Keystroke emulation editor?



I do not have any controls to add, duplicate or close.  I have maximised the window and right clicked everywhere.
Makes it impossible to map multiple keys.

Thanks
Brent

H4 decoder - leave it alone then thanks. 

In Mame most hi/lo games just have a gear change button - one single - surely it will get out of sync if i was to map to all 4 buttons?

Thanks

Hi All
Great bit of software!
I am waiting on the PWM2HAPP board so in the meantime am setting up all buttons and lights.

Cruisin USA conversion
Question on the H-Shifter.
4 gears - 4 switches all setup in backforcefeeder.
What good does the H4 shifter decoder do?  Is it any use to me?
Finally - for the Hi/Lo only games - how do I map that so low is 1st or 3rd (top of H shifter) and Hi is 2nd or 4th?
I read about turning toggle off in Mame game.cfg files but wondered if something could be done in backforcefeeder to get the same results.

Many thanks
Brent